Spare Parts; User Instructions - Heatrae Sadia MULTIPOINT 75 Fitting Instructions And User Manual

10.0 SPARE PARTS

The following comprehensive list of spare parts is available for your
Multipoint water heater. Please refer to the Rating Label on the side of your
heater before ordering to ensure the correct spare part is obtained.
DO NOT REPLACE WITH PARTS NOT RECOMMENDED BY HEATRAE
SADIA. THIS WILL INVALIDATE YOUR GUARANTEE AND MAY RENDER
THE INSTALLATION DANGEROUS.
1
2
3
4
5
6
7
8
1. Temperature/Pressure Relief Valve ........... 95 605 045
2. Expansion Vessel ...................................... 95 607 045
3. Fixing Bracket (75 Litre) ............................ 95 607 046
3. Fixing Bracket (100 Litre) .......................... 95 607 047
4. Thermostat ................................................ 95 612 019
5. Thermal Cut-Out ....................................... 95 612 020
6. Element Plate Assembly - 3kW ................ 95 606 926
6. Element Plate Assembly - 1.5 kW ............ 95 606 960
7. Fixing Bracket Bolts (pack of 6) ................ 95 607 050
8. Terminal Cover Screws (pack of 5) ........... 95 607 051
9. Flexible hose ............................................. 95 607 049
14
10. Indicator Light .......................................... 95 607 048
11. Pressure (Expansion) Relief Valve .......... 95 607 737
12. Check Valve ............................................. 95 607 987
13. Gasket (pack of 10) ................................. 95 611 708
14. Terminal Cover ........................................ 95 614 086
15. Pressure Reducing Valve ........................ 95 607 989
11.0 ACCESSORIES
The heater can be used to supply several hot water outlets via conventional
taps. Individual site demands should be considered when choosing
capacity and the number of outlets to be served.
A Thermostatic Blending Valve can be used in conjunction with the
Multipoint Water Heater. Heatrae Sadia supply both TMV2 approved (Pack
U3, code number 95 970 354) and TMV3 approved (Pack U7 95 970 360)
9
Thermostatic Blending Valves.
10

12.0 USER INSTRUCTIONS

11
12.1 The temperature can be adjusted by rotating the thermostat controls
12
13
14
12.2 The indicator lights will be illuminated when the unit is heating.
12.3 To ensure the heater continues to operate at its optimum performance
12.4 IMPORTANT NOTES TO USER
located inside the terminal cover. It is recommended that both
thermostats are set at position 6 (approximately 60°C) however they
can be adjusted between settings 1 to 7 (5°C to 75°C).In hard water
areas it is advised that the maximum temperature is restricted to
prevent build up of scale. To avoid risk of freezing when the heater is
not in use for long periods during the winter months, do not switch off
the electrical supply and set the thermostat to its minimum position.
N.B. This will not protect other system pipework.
it should be periodically maintained in accordance with the instructions
given under the section headed MAINTENANCE.
DO NOT BLOCK OR RESTRICT THE DISCHARGE FROM ANY
SAFETY VALVE FITTED.
DO NOT TAMPER WITH ANY SAFETY VALVE FITTED.
IF WATER DISCHARGES FROM ANY SAFETY VALVE FITTED
SWITCH OFF THE ELECTRICAL SUPPLY TO THE UNIT
IMMEDIATELY. CONTACT THE HEATRAE SADIA SERVICE TEAM
(TEL: 0844 8711535) OR AN APPROVED INSTALLER. DO NOT
TURN THE ELECTRICAL SUPPLY ON AGAIN UNTIL THE UNIT HAS
BEEN CHECKED AND APPROVED BY A QUALIFIED INSTALLER.
15