OWC Mercury Elite Pro Dual mini Assembly Manual & User Manual page 6

Hide thumbs Also See for Mercury Elite Pro Dual mini:
Table of Contents

Advertisement

2. Tilt the Mercury Elite Pro Dual mini up
at the front to allow the back plate to
fall free. Note the three DIP switches
in the blue block to the left of the on/
off switch. You will use these switches
to configure the desired RAID mode.
For now, set aside the back plate and
continue to step 3.
NOTE: You are now able to access the
DIP switches to change the RAID mode
of the Mercury Elite Pro Dual mini. See
Section 2.3, RAID Settings for in-
structions on how to change the RAID
mode.
4. Once the inner chassis has been re-
moved from the outer enclosure,
note the two SATA connectors on
the right. There are also eight screw
holes: four through the metal on the
left and four through the green cir-
cuit board on the right. These are the
items that you will use to secure your
drives to the inner chassis.
OWC MERCURY ELITE PRO DUAL MINI
3. Gently push on the inner chassis
that was exposed by removing
the back plate. The inner chassis
should slide easily out of the
outer enclosure. Once there is
enough room at the front, as
shown to the left, you can pull
on the front of the inner chassis
to remove it fully.
4
SYSTEM SETUP

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Mercury Elite Pro Dual mini and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents