Desa VUL18NR Owner's Operation And Installation Manual page 19

Unvented (vent-free) gas log heater
Table of Contents

Advertisement

INSTALLING LOGS
WARNING: Failure to posi-
tion the parts in accordance
with these diagrams or failure
to use only parts specifically
approved with this heater may
result in property damage or
personal injury.
Each log is marked with a number. These
numbers will help you identify the log when
installing. It is very important to install these
logs exactly as instructed. Do not modify logs.
Only use logs supplied with heater.
Note: Your appliance may vary from model
shown but log placement will be the same.
VUL36 Model brackets
If installing a VUL36 model, attach log support
brackets before installing logs.
1. Install left bracket to left side of chassis us-
ing 2 screws provided (see Figure 25).
2. Install right bracket to right front of chassis
using 2 screws provided (see Figure 25).
This bracket will also be used as remote
control bracket if remote is installed.
Left Log
Support
Bracket
Right Front of Chassis
Figure 25 - Installing Log Support
Brackets
122001-01C
INSTALLATION
Chassis
Right Log
Support
Bracket
www.desatech.com
Continued
Installing Logs (All Models)
1. Place bottom log in center of the base as-
sembly as shown in Figure 26.
2. Rest rear log in back corner sections of
base assembly as shown in Figure 26.
Make sure log is completely vertical and
not leaning in toward burner where flame
will touch the log.
3. Position front right log against right side
of grate prongs (see Figure 26).
4. Position front left log against left side of
grate prongs (see Figure 26).
5. Place middle right log over front right and
bottom logs as shown in Figure 27, page
20. Be sure hole in middle right log seats
over pin in bottom log.
6. Place middle left log over front left and
bottom logs as show in Figure 27, page
20. Be sure hole in middle left log seats
over pin in front left log.
7. For VUL36 models, the front right and
left logs are longer and are supported
with brackets on each end (see Figure
28, page 20). Place left and right small
front logs under left bracket and beside
right bracket.
Grate
Prongs
Bottom Log
Base Assembly
Figure 26 - Installing Log Set
Front Left
Log
Rear Log
Front
Right Log
19

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents