Desa VUL18NR Owner's Operation And Installation Manual page 18

5. Remove heater base from fireplace.
6. Install receiver bracket to base with Phil-
lips screws provided in hardware kit as
shown in Figure 20.
7. Disconnect jumper wire from control valve at
TPTH and TH locations (see Figure 21).
8. Install remote receiver into receiver
bracket using pads and push button clips
provided with receiver (see Figure 22).
9. Connect wires to control valve at the
TPTH and TH locations as shown in
Figure 23.
Note: Make sure excess wire does not
interfere with burner or pilot.
10. If heater was removed from fireplace be-
fore installation of remote accessory, see
Installing Heater Base Assembly on page
13 to reinstall heater into fireplace. Test
gas connection for leaks (see Checking
Gas Connections, page 16).
Phillips
Screws
Remote Receiver Bracket
Figure 20 - Installing Remote Receiver
Bracket
Control Valve
Figure 21 - Disconnecting Jumper Wire
From Control Valve
Push Button
Clips
Bracket
Figure 22 - Installing Remote Receiver
18
INSTALLATION
Continued
Jumper
Wire
9-Volt
Battery
Battery
Clip
Pad
Terminal
Wires
www.desatech.com
11. If logs were removed from heater for in-
stall remote accessory, replace logs (see
Installing Logs, page 19).
Control Valve
Figure 23 - Connecting Wires
Installing Batteries for Remote Receiver
and Hand Held Remote Control
Two 9-volt alkaline batteries (not included)
are required to operate this heater with the
wireless hand-held remote control set. One
battery must be installed in the receiver and
one in the hand-held remote control unit.
Note: Only use alkaline batteries.
Installing 9-Volt Battery in Receiver
1. Locate back of receiver behind receiver
bracket mounted on base assembly.
2. Locate the battery clip mounted on the
back of the receiver (see Figure 22).
3. Slide a 9-volt battery through the clip.
4. Attach the terminal wires to the battery.
Installing 9-Volt Battery (Not Included) in
Hand-Held Remote Control Unit
1. Remove battery cover on back of remote
control unit.
2. Attach terminal wires to the battery. Place
battery into the battery housing.
3. Replace battery cover onto remote con-
trol unit.
Battery Cover
Terminal
Wires
9-Volt
Battery
Figure 24 - Installing Battery in Hand-Held
Remote Control Unit
White Wire
From Receiver
Red Wire From
Receiver
Remote Control
Unit
Battery
Housing
122001-01C