Initial Programming - Bosch Indego Original Instructions Manual

OBJ_BUCH-1573-003.book Page 27 Friday, November 23, 2012 9:10 AM
connect the wire to the right hand (red) terminal. (see
figures 4 – 5)
Fix the docking station with 4 supplied fixing pins to the
ground. (see figure 6)
Lay out the perimeter wire anti-clockwise and flush to the
ground. Observe the minimum distances from lawn edges,
steps, walls, ponds, etc. Use the spacing guide. (see figure 7)
Trees, ponds, flower beds, etc. on the lawn must be delimited
in clockwise direction. The lines to and from these zones may
not cross but the wire should be touching. (see figure 7)
Fix the wire with the first peg next to the docking station, ten-
sion and fix with pegs at a distance of approx. 50 cm. (see
figure 7)
Continue the loop and bring the wire to the back of the dock-
ing station and inline with the other end of the wire. Fix the
second end of the wire also with the peg. Perimeter wire and
peg should be installed inline. Shorten the wire, cut off insula-
tion carefully and connect the wire to the left hand (black) ter-
minal. (see figure 8)
Clip on the protective cover of the docking station. (see
figure 9)
Note: The wire can be extended up to the maximum allowed
length of 450 m.
Note: If verticutting or raking is intended avoid the perimeter
wire.
Install the power supply in a cool, dry environment. Connect it
with the docking station and an indoor mains socket. (see
figure 10)
Check the indicator on the docking station (see figure 11):
– Indicator lights up continuously green, if the output volt-
age of the power supply is available and the perimeter wire
is not interrupted.
– Indicator flashes green, if the perimeter wire is broken,
long or short.
– Indicator does not light up when the output voltage of the
power supply is not available.

Initial Programming

Plug the isolator key into the machine and put it into the dock-
ing station for charging. (see figures 12 – 14)
The welcome screen appears and shows following symbols:
Robotic Lawnmower
Symbol Meaning

Multifunctional buttons, left

Battery capacity

Title of Menu/Submenu
Bosch Power Tools
Symbol Meaning

Display with dialog screens

Time

Multifunctional buttons, right
The buttons are multifunctional. The meaning depends on the
individual menu function and is explained on the screen.
The buttons next to the arrow symbols
gate up or down through the menu options. The buttons next
to the arrow symbols or allow to go right or left through
the menu options.
The display will change to the next screen as soon as any op-
tion is selected and confirmed.
Installation
First press the button next to "Language choice". The "Set
Language" screen appears and shows the following.
Set Language
English
Deutsch
Dansk
Svenska
Norsk
Suomi
Select one of the "Language" options and confirm with
"Save".
PIN Code
Please set up PIN Code
Select "Proceed" to enter your personal PIN Code.
PIN Code
Enter new PIN:
__ _ _
Back
Select the input position with the left/right cursors, adjust the
digits with the up/down cursors and confirm with "Enter" or
select "Back" to return to the first "PIN Code" screen.
English | 27
or allow to navi-
Save
Proceed
Enter
F 016 L70 825 | (23.11.12)