Battery Charging; Menu Navigation - Bosch Indego Original Instructions Manual

OBJ_BUCH-1573-003.book Page 30 Friday, November 23, 2012 9:10 AM
30 | English
– obstruction sensor, tactile detection for obstacle any-
where in the full width of the path of the machine and cause
the machine to change its direction
– tilt sensor, will be activated if the machine reaches an an-
gle of 45°
If one of the sensors is activated, such as lift sensor, the
screen will show a message, e. g. "Machine has been lifted.
Please enter PIN code to continue". The display switches into
sleep mode, if no input is made for 3 minutes. Press any but-
ton to reactivate the screen.
If the machine is in sleep mode, press any button to change to
the PIN entry screen and enter the PIN code.

Menu Navigation

Following tables show the various menu items.
Settings
Mow Settings Border Cut
Cutting lane prox-
imity
Signal ID
Delete Maps
Security Options Change PIN
Auto Lock
Set Language
System Options Set Keypad
Volume
Set Display
Info
Factory Reset
Set Time & Date
F 016 L70 825 | (23.11.12)

Battery Charging

The battery is equipped with temperature monitoring that al-
lows charging only in the temperature range between 5 °C
and 45 °C.
The Lithium-Ion battery is supplied partially charged. To en-
sure full capacity of the battery, completely charge the ma-
chine in the docking station before first use.
The Lithium-Ion battery can be charged at any time without
reducing its service life. Interrupting the charging procedure
does not damage the battery.
When the battery is run down or discharged, the machine is
shut off by means of a protective circuit: the blade no longer
moves.
Explanation
Never Machine never cuts lawn border.
Every 4th time Machine cuts lawn border every 4th mowing.
Every 2nd time Machine cuts lawn border every 2nd mowing.
Set the proximity of the cutting lane
Choice of different signals, if there is any signal interfer-
ence.
Machine will map garden again.
Note: Machine should be in the docking station
PIN code is required for reactivation after auto-lock and
safety shut-down.
Changing of a PIN code needs entering of existing PIN
code first.
On If buttons are not pressed for 3 min. they will be auto-
matically locked.
Recommended for safety reasons and protection
against theft.
Off Buttons are always ready for input.
Change of displayed language.
Set the volume of the keypad.
Display Set the display brighter or darker.
Brightness
Information about software version, serial number and
last service.
Reset of the machine to factory setting will delete all per-
sonal settings.
A factory reset will require to repeat installation.
Edit date and time.
Bosch Power Tools