Technical Information - Panasonic CF-72 Series Reference Manual

Technical Information

Network
When Adding New Software or Hardware Components
When the power saving function is running, communications software may malfunc-
tion. For example, communications may be halted if the standby (hibernation) mode
is activated. The computer must be restarted if one of these modes is entered during
data communications.
Be sure that the power of the display is off (for energy conservation purposes) or the
computer enters standby (hibernation) mode after the communications software is
closed.
Windows 98
The network connection may be severed under the condition the
power of the display is off (for energy conservation purposes) and
standby (hibernation) mode. When network or communication soft-
ware is to be used, set [System standby], [Turn off monitor] and [Turn
off hard disks] (in [Start] - [Settings] - [Control Panel] - [Power Man-
agement]) to [Never].
Windows NT
The network connection may be severed when entering the ECO
mode and standby (hibernation) mode. Be sure to disable the
[Standby/Hibernation Timeout]* settings with the Setup Utility if you
require a network environment. The computer will not operate prop-
erly. If this occurs, restart the computer.
* Since access to the hard disk occurs often on Windows NT, standby/hiber-
nation timeout may not function according to the set times. However, be
sure to set off just to be safe.
Windows 2000
The network connection may be severed under the condition the
power of the display is off (for energy conservation purposes) and
standby (hibernation) mode. When network or communication soft-
ware is to be used, set [System standby], [System hibernates], [Turn
off monitor] and [Turn off hard disks] (in [Start] - [Settings] - [Control
Panel] - [Power Options]) to [Never].
Some of the contents of Service Pack 6 (installed at the time of purchase) may be
overwritten. Therefore, after adding a new software or hardware component, be sure
to install (UPDATE) Service Pack 6. (See the c:\sp6\readme.htm file.)
<Only if necessary>
In addition, if you install Service Pack 6, some files of Phoenix APM 2.0 for Windows NT
and Phoenix Card Executive 2.0 for Windows NT
after installing Service Pack 6, also re-install Phoenix APM 2.0 for Windows NT
Phoenix Card Executive 2.0 for Windows NT
At times you may be prompted to copy Windows NT
copy source and select [OK].
<Installing Service Pack 6>
In [Start] - [Run], input [c:\sp6\sp6i386.exe], then press [OK]. Follow the on-screen
instructions.
Windows NT
®
may be overwritten. Therefore,
®
.
®
files. Input [c:\winnt\i386] as the
60
®
®
and