Starting Operation - Bosch GSR Professional 9,6-2 Original Instructions Manual

OBJ_BUCH-585-001.book Page 20 Thursday, November 8, 2007 1:37 PM
20 | English
Operation

Starting Operation

Inserting the Battery
Use only original Bosch O-pack batteries
with the voltage given on the type plate of
your machine. The use of other batteries can
lead to injuries and danger of fire.
Set the rotational direction switch 9 to the centre
position in order to avoid unintentional starting.
Insert the charged battery 6 into the handle so
that it can be felt to engage and faces flush
against the handle.
Reversing the Rotational Direction
(see figure E)
The rotational direction switch 9 is used to re-
verse the rotational direction of the machine.
However, this is not possible with the On/Off
switch 10 actuated.
Right Rotation: For drilling and driving in screws,
push the rotational direction switch 9 left to the
stop.
Left Rotation: For loosening or unscrewing
screws, push the rotational direction switch 9
right to the stop.
Setting the Torque
The required torque can be preselected in 25
steps with the torque preselection ring 4. With
the correct setting, the insert tool is stopped as
soon as the screw is screwed flush into the ma-
terial or when the set torque is reached.
Select a higher setting when driving out screws,
or set to the symbol "Drilling".
1 609 929 M79 | (8.11.07)
Gear Selection, Mechanical
Actuate the gear selector 5 only when the
machine is at a standstill.
Two speed ranges can be preselected with the
gear selector 5.
Gear I:
Low speed range; for screwdriving or working
with large drilling diameter.
Gear II:
High speed range; for working with small drilling
diameter.
If the gear selector 5 cannot be pushed through
to the stop, lightly turn the drill chuck with drill.
Switching On and Off
To start the machine, press the On/Off switch 10
and keep it depressed.
To switch off the machine, release the On/Off
switch 10.
Adjusting the Speed
The speed of the switched on power tool can be
variably adjusted, depending on how far the
On/Off switch 10 is pressed.
Light pressure on the On/Off switch 10 results in
a low rotational speed. Further pressure on the
switch results in an increase in speed.
Run-on Brake
When the On/Off switch 10 is released, the
chuck brakes to a stop, thus preventing the run-
on of the tool.
When driving in screws, wait until the screw is
screwed in flush with the material and then re-
lease the On/Off switch 10. By doing so, the head
of the screw does not penetrate into the materi-
al.
Bosch Power Tools