Starting Operation - Bosch IXO Original Instructions Manual

The torque presetting ring (18) on the torque setting adapter (17) can be
used to pre-select the required torque in 10 stages. When the correct set-
ting is used, the bit will be stopped as soon as the screw is driven flush into
the material or as soon as the set torque has been reached.
Fitting (see figures C–D)
To fit the adapters, pull off the rubber cap (3) towards you. Then the ad-
apters can be attached. It is possible to fit an adapter offset by 45°.
Removal (see figures E–F)
To remove an adapter, turn the unlocking ring (20) in rotational direction ➊
and pull the adapter off towards you. Then reattach the rubber cap (3).
Operation

Starting Operation

Setting the rotational direction
The rotational direction switch (5) is used to change the rotational direction
of the power tool. However, this is not possible while the on/off switch (7) is
being pressed.
Only operate the rotational direction switch (5) when the power tool
u
is not in use. Otherwise it may become damaged.
Clockwise rotation: To drive in screws, slide the rotational direction switch
(5) forward to the stop.
Anti-clockwise rotation: To loosen or unscrew screws, slide the rotational
direction switch (5) backwards.
Switching on/off
To start the power tool, press and hold the on/off switch (7).
The worklight (10) lights up when the on/off switch (7) is lightly or fully
pressed, allowing the work area to be illuminated in poor lighting conditions.
To switch off the power tool, release the on/off switch (7).
Fully automatic spindle lock (Auto-Lock)
The drill spindle is locked when the on/off switch (7) is not pressed.
This allows screws to be driven in even when the battery is discharged and
enables the power tool to be used as a screwdriver.
Bosch Power Tools
English | 31
1 609 92A 66B | (10.12.2020)