Starting Operation - Bosch IXO Original Instructions Manual

16 | English
The angle screw adapter (15) allows you to drive in screws in hard-to-reach
areas.
Assembly (see figures C – D)
To fit the adapters, pull off the rubber cap (3) towards you. Then the ad-
apters can be attached. The attachments can be mounted offset by 45° re-
spectively.
Removal (see figures E – F)
To remove the attachments, turn the unlocking ring (16) in the rotational
direction ➊ and pull the adapter off towards you. Then reattach the rubber
cap (3).
Operation

Starting Operation

Setting the rotational direction
The rotational direction switch (5) is used to change the rotational direction
of the power tool. However, this is not possible while the on/off switch (8) is
being pressed.
Clockwise rotation: To drive in screws, slide the rotational direction switch
(5) forward to the stop.
Anti-clockwise rotation: To loosen or unscrew screws, slide the rotational
direction switch (5) backwards.
Switching on/off
To start the power tool, press and hold the on/off switch (8).
The worklight (9) lights up when the On/Off switch (8) is lightly or fully
pressed, allowing the work area to be illuminated in poor lighting conditions.
To switch off the power tool, release the on/off switch (8).
Adjusting the Speed
You can adjust the speed of the power tool when it is on by pressing in the
on/off switch (8) to varying extents.
A light pressure on the on/off switch (8) results in a low rotational speed. In-
creased pressure on the switch causes an increase in speed.
1 609 92A 5RW | (12.05.2020) Bosch Power Tools
Autogoods "130"