Table of Contents
Advertisement
Lighting the burners
To obtain a flame more easily, light the burner before placing a cooking
utensil on the pan stand
To light a burner, proceed as follow: for version with lighting integrated in
the control knob push the knob of the burner fully down and turn it
anticlockwise to the "maximum flow" setting symbol, or press the button if
the appliance has individual lighting.
After lighting the flame, keep the knob pressed for about 10 seconds: this
time is necessary to heat up the "thermocouple" (Fig.2) and activate the
safety valve, which would otherwise cut off the gas flow.
Then check that the flame is even and turn the control knob to adjust the
flame as required.
In the instance of a power cut, place a flame near the burner and proceed as already
described.
If the flame does not light after a few attempts, check that the "burner cap" and
"flame cap" are correctly positioned.
To turn off the flame, turn the control knob clockwise to the ● symbol.
Before removing pans from the burners, always lower or turn off the flame.
For correct use of the hob
For lower gas consumption and better
dimensions suitable for the burners as shown in the table below. Also, as soon as a
liquid comes to the boil take care to turn the flame down to a level that will just keep
it boiling.
Burner
Large(rapid)
Medium(semi-rapid)
Small(Auxiliary)
Triple Flame
During cooking processes involving fats or oils, watch your foods
carefully because these substances may catch fire if brought to high
temperatures.
efficiency:
minimum diameter
180mm
120mm
80mm
220mm
Use only flat-bottomed pans of
maximum diameter
220mm
200mm
160mm
260mm
8
Hide quick links:
Advertisement
Table of Contents
