Listening To The Radio; Tuning Down Button; Tuning Up Button; Tuner (Band) Button - Sharp GX-CD5200V Operation Manual

■ To change the audio mode
Sound of the playback source can be switched among the STEREO,
L-CH, R-CH, and V-CANCEL (VOCAL CANCEL) modes.
The audio mode function is used when the left and right channels
have individual signals from each other.
Press the VCD AUTO/VCD/AUDIO
MODE button on the remote
control until the desired audio
mode is displayed.
Each time the VCD AUTO/VCD/
AUDIO MODE button is pressed,
the mode will change as follows:
STEREO
STEREO
L-CH
R-CH
V-CANCEL
Notes:
● The initial audio mode setting is "STEREO".
● When playing a sound multiplexed disc on which a vocal and
music have been separately recorded, select the audio mode as
desired.
Downloaded From Disc-Player.com Sharp Manuals
L-CH R-CH V-CANCEL
Sounds on the left and right channels are played.
Sounds on the left channel only are played.
Sounds on the right channel only are played.
The main vocal is lowered.

Listening to the radio

■ Tuning
1
Press the ON/STAND-BY button to turn the power on.
2
Press the TUNER (BAND) button repeatedly to select the
desired frequency band (FM, SW-1, SW-2 or MW).
3
Press the TUNING ( or ) button to tune in to the desired
station.
Manual tuning:
Press the TUNING button as many times as required to tune in
to the desired station.
Auto tuning:
When the TUNING button is pressed for more than 0.5
seconds, scanning will start automatically and the tuner will stop
at the first receivable broadcast station.
Notes:
● When radio interference occurs, auto scan tuning may stop
automatically at that point.
● Auto scan tuning will skip weak signal stations.
● To stop the auto tuning, press the TUNING button again.
04/1/28 CX-GD5200V_EN2.fm
GX-CD5200V
ENGLISH
E-28