Systemkomponenten Anschluss Öffnen Sie die Box und entnehmen Sie das Steuergerät, die Anschlusskabel und das Ver- Montieren Sie das Steuergerät und den Satelliten Receiver im Fahrzeuginneren nicht packungsmaterial. Heben Sie die Antenne gerade nach oben aus der Verpackung. Stel- im Bereich eines Airbags. Achten Sie auf eine sorgfältige Verlegung der Kabel, um Kurz- len Sie die Anlage niemals auf den Kopf! schlüsse zu vermeiden.
Das Steuergerät Satellitenübertragung Vorderansicht des Steuergerätes Direct Broadcast Service (DBS) strahlt Audio, Video und Daten über den Satelliten aus, der sich in 35 km Höhe über der Erde befindet. Mit einer Empfangsstation wie die Antenne und einem Satelliten Receiver werden die Signale vom Satelliten empfangen und verar- LCD Display Satellitenauswahl beitet.
1. Schalten Sie den Fernseher und den Satelliten Receiver ein. Achten Sie darauf, dass die Folgende Einstellungen sind nur für den LNB Versorgungsspannung im Receiver eingeschaltet ist. Seaman 37 (ohne Auto Skew). Eine Übersicht 0° der Skew Einstellwerte finden Sie auf Seite 11.
• Vergewissern Sie sich, dass in den Einstellungen des Receivers die LNB Spannung eingeschalten ist. • Nur bei Seaman 37 (ohne AutoSkew) Sollte die Antenne keinen Satelliten finden, überprüfen Sie die Skeweinstellung des Satelliten für ihren Standort. Eine Übersicht der Skew Einstellwerte finden Sie auf Seite 11.
Firmware Update Updatevorgang: 1. Schalten Sie das Steuergerät aus. Wenn die Frequenz, auf der die Antenne den Satelliten idendifiziert, abgeschaltet wird, muss ein Firmwareupdate des Steuergerätes durchgeführt werden. 2. Stecken Sie die SD Karte in den Slot auf der Rückseite des Steuergerätes. Die aktuelle Firmware Version des Steuergerätes können Sie in den ersten 3 Sekunden 3.
Ausleuchtzone Technische Daten Seaman 37 Seaman 45 GPS/AutoSkew Seaman 37 Seaman 45 Seaman 60 Antennen Typ ............Off-Set-Spiegel ...... Off-Set-Spiegel ...... Off-Set-Spiegel Anzahl der Teilnehmer .........3 ............3 ............3 LNB Typ ..............Universal LNB ......Universal LNB ......Universal LNB Frequenzband ..........Ku Band ........Ku Band ........Ku Band Frequenzbereich ..........10.7 GHz bis 12.75 GHz ..
Page 9
Brillantes Fernsehen Brillantes Fernsehen Seaman 37 Seaman 45 GPS/Auto Skew Seaman 60 English GPS/Auto Skew Stand: v2.1 Februar 2014 User manual and installation instruction...
Page 10
Contents Safety Information Caution – Improper handling by unqualified personnel can cause serious damage to this equipment. Unqualified personnel who tamper with this equipment may be held liable for any resultant damage to the equipment. Note – Before you begin, carefully read each of the procedures in this ma- nual.
System Components Connection Open box and remove the control unit, cables and packing material. Lift the antenna Install the control unit and the set-top box is not inside the vehicle in the region of an straight up out of the box. Never place the system upside down! airbag.
Satellite broadcasting The contron unit Front view of the control unit Direct Broadcast Service (DBS) satellites broadcast audio, video and data information from satellites located 22 miles in space. A receiving station, such as the antenna, should include a dish and satellite receiver to receive the signals and process them for use by the LCD Display Satellite Select consumer audio and video equipment.
1. Turn on the TV and the set-top box. The green LNB LED on the display of the control The following settings are only for the box lights up when the satellite receiver is turned on and a supply voltage for the LNB Seaman 37 (without AutoSkew). An overview 0° is available.
• Make sure that the settings of the set-top box to LNB voltage is switched on. This is indicated by the green LED on the control unit (LED green = LNB voltage present). • Only Seaman 37 (without AutoSkew) If the antenna has not found satellites, check the Skew settings for the satellite at your location.
Firmware Update Update process: 1. Turn off the controller. When the frequency is switched off, on which the antenna idendifiziert the satellite, you must update the firmware of the control unit. 2. Insert the SD card into the slot on the rear side of the control unit. The current firmware version of the control unit, you can read on the bottom of the 3.
Footprint Specifications Seaman 37 Seaman 45 GPS/AutoSkew Seaman 37 Seaman 45 Seaman 60 Antenna typ ............Off-Set-Dish ......Off-Set-Dish ......Off-Set-Dish Users ................3 ............3 ............3 LNB typ ..............Universal LNB ......Universal LNB ......Universal LNB Frequency band ..........Ku Band ........Ku Band ........Ku Band Frequency range ..........10.7 GHz to 12.75 GHz ..
Need help?
Do you have a question about the Seaman 37 and is the answer not in the manual?
Questions and answers