Mains Part - Sanitas SBM 50 Instructions For Use Manual

invasive sphygmomanometers, Part 1: General require-
ments), EN 1060-3 (non-invasive sphygmomanometers,
Part 3: Supplementary requirements for electro-mechani-
cal blood pressure measuring systems) and IEC 80601-2-
30 (Medical electrical equipment – Part 2 – 30: Particular
requirements for the safety and essential performance of
automated non-invasive blood pressure monitors).
• The accuracy of this blood pressure monitor has been
carefully checked and developed with regard to a long
useful life. If using the device for commercial medical pur-
poses, it must be regularly tested for accuracy by appro-
priate means. Precise instructions for checking accuracy
may be requested from the service address.

12. Mains part

Model No. FW 7575M/EU/6/06
Input 100 – 240 V, 50 – 60 Hz
Output 6 V DC, 600 mA, only in connection
with
Supplier Friwo Gerätebau GmbH
blood pressure monitor
Sanitas
Protection
Enclosures and
Protective Covers
29
This device is double insulated
andprotected against short circuit
andoverload by a primary thermal
fuse. Make sure to take the batteries
out of the compartment before using
the mains part.
double insulated /equipment class 2
Polarity of the the DC voltage con-
nection
Equipment enclosed to protect
against contact with live parts, and
with parts which can become live
(finger, pin, hook test). The operator
shall not contact the patient and the
output plug of AC mains part simul-
taneously.