Mounting The Stand (Optional) - PSC QuickScan 3000 Product Reference Manual

QuickScan QS3000/QS3500 Product Reference Guide

Mounting the Stand (optional)

You can attach the base of the scanner's stand to a flat surface using two screws or double-
sided tape (not provided).
Screw Mount
1. Position the assembled base on a flat surface.
2. Screw one #10 wood screw into each screw-mount hole until the base of the stand
is secure (see
Tape Mount
1. Peel the paper liner off one side of each piece of tape and place the sticky surface
over each of the three rectangular tape holders.
2. Peel the paper liner off the exposed sides of each piece of tape and press the stand
on a flat surface until it is secure (see
Note: Mounting the stand is optional.
2-10
Two screw-mount holes.
Figure 2-6. Mounting the Stand
Figure 2-6).
Double-sided tape
areas
(3 places)
dimensions = 1" x 2")
Figure 2-6).