Table of Contents
Advertisement
QuickScan QS3000/QS3500 Product Reference Guide
Setup Field(s)
Parameter
Move Cursor
Move Cursor To a Character
Move Cursor to Start of Data
Move Cursor Past a Character
Skip Ahead "N" Characters
Skip Back "N" Characters
Send Preset Value
13-28
Table 13-1. Setup Field(s) Definitions
Scan the
Move Cursor To Character
, then any printable ASCII
on page 13-29
character from the
When this is used, the cursor moves to the
position after the matching character. If the
character is not there, the rule fails and ADF
tries the next rule.
Scan this bar code to move cursor to the
beginning of the data.
This parameter moves the cursor past all
sequential occurrences of a selected character.
For example, if the selected character is 'A',
then the cursor moves past 'A', 'AA', 'AAA', etc.
Scan the
Move Cursor Past Character
code on page 13-29
the
Alphanumeric
not there, the cursor does not move (i.e., has no
effect).
Scan one of these bar codes to select the
number of positions ahead you wish to move
the cursor.
Scan one of these bar codes to select the
number of positions back you wish to move the
cursor.
Send Values 1 through 6 by scanning the
appropriate bar code. These values must be set
using the prefix/suffix values in
page
6-22.
Value 1 = Scan Suffix
Value 2 = Scan Prefix
Description
Alphanumeric
Keyboard.
, then select a character from
Keyboard. If the character is
Table 6-4 on
Page
bar code
13-29
13-29
13-29
bar
13-30
13-32
13-34
Advertisement
Table of Contents
