Table of Contents
Advertisement
QuickScan QS3000/QS3500 Product Reference Guide
Laser On Time
This parameter sets the maximum time that decode processing continues during a scan
attempt. It is programmable in 0.1 second increments from 0.5 to 9.9 seconds. The default
Laser On Time is 3.0 seconds.
To set a Laser On Time, scan the bar code below. Next, scan two numeric bar codes
beginning on page
D-1
in
Appendix D
that correspond to the desired on time. Single digit
numbers must have a leading zero. For example, to set an On Time of 0.5 seconds, scan
the bar code below, then scan the "0" and "5" bar codes. If you make an error, or wish to
change your selection, scan Cancel on page D-5.
Laser On Time
4-8
Advertisement
Table of Contents
