To Select A Direct-To By Identifier; To Select A Direct-To By City Or Facility Name; To Select A Direct-To From A List Of Way-Points In Active Flight Plan; To Select A Specific Course To A Waypoint - Garmin G1000 Pilot's Manual

To select a Direct-to by identifier:
Press the Direct-to key, then turn the FMS knobs
1.
to select the desired waypoint identifier. Press
the ENT key to confirm the selection. Press the
ENT key again to activate the direct-to.
Figure 3.6.12 Direct-to Window
NOTE: When entering an all-letter/alphabetical
airport identifier (only in the USA), the pilot must
precede it with the letter "K" (KMCI). If the
airport identifier is alpha-numeric, simply enter
the three-digit identifier (51K). The full ICAO
identifier must be entered for all waypoints.

To select a Direct-to by city or facility name:

1. Press the Direct-to key, then turn the large FMS
knob to highlight the city field (to the right of
the identifier) or facility field (directly below
the identifier) field.
2. Turn the FMS knobs to enter the city (to the
right of the identifier field), or the facility
(directly below the identifier field). Once the
desired city or facility name is displayed, press
the ENT key to confirm the selection. Press the
ENT key again to activate the direct-to.
190-00387-02 Rev. A Garmin G1000 PFD Pilot's Guide for Cessna Nav III
SUPPLEMENTAL FLIGHT DATA
To select a Direct-to from a list of way-
points in an active flight plan:
1. Press the Direct-to key, then turn the large FMS
knob to highlight the FPL field.
2. Turn the small FMS knob to display a selection
window showing all waypoints in the active
flight plan.
3. Turn the FMS knob to scroll through the list and
highlight the desired waypoint, then press the
ENT key. Press the ENT key again to activate the
direct-to.
To select a Direct-to from the Nearest Air-
ports list:
1. Press the Direct-to key, then turn the large FMS
knob to highlight the NRST field.
2. Turn the small FMS knob to display a selection
window showing the 25 nearest airports.
Turn the FMS knob to scroll through the list
3.
and highlight the desired airport, then press
the ENT key. Press the ENT key again to activate
the direct-to.
To select a specific course to a waypoint:
1. Press the Direct-to key, then turn the FMS knobs
to select the desired destination waypoint, then
press the ENT key.
Turn the large FMS knob to highlight the 'CRS'
2.
field. Turn the FMS knobs to select the desired
course and press the ENT key.
Press the ENT key to activate the direct-to using
3.
the selected course to the destination.
3-35