Kobalt CDT212KU User Manual page 11

OPERATING INSTRUCTIONS
3. The drill has a two-speed gear control (C)
designed for drilling or driving at LO (1) or HI (2)
speeds. A slide switch is located on top of the
drill to select either LO or HI speed. When using
the drill in the LO speed range, the speed will
decrease and the drill will have greater power
and torque. When using the drill in the HI speed
range, the speed will increase and the drill will
have less power and torque.
GEAR 1: Low speed range for screwdriving or
working with large drilling diameter.
GEAR 2: High speed range for working with
small drilling diameter.
WARNING
To prevent gear damage, ALWAYS allow the
chuck to come to a complete stop before
changing the gear speed.
4. With the chuck (A) facing you, rotate the chuck
selector (B). The torque is greater when the
E-torque selector is set on a higher setting. The
torque is less when the E-torque selector is set
on a lower setting.
Make the setting as follows:
TORQUE
SETTING
1-4
5-9
10-15 Driving screws into soft and hard material
PURPOSE
Driving small screws
Driving screws into soft material
Heavy drilling
3
4
L
5
B
11
C
A
kobalttools.com