Kobalt CDT212KU User Manual page 10

OPERATING INSTRUCTIONS
BELT CLIP
1. The belt clip is attached with a small screw.
Simply unscrew the clip to move it to the opposite
side of the drill. The belt clip (G) can be hooked
on your belt or pocket, etc.
DRILL FEATURES
1. Depress the On/Off switch (J) to start and
release it to stop your drill. The LED light (K) will
turn on when you press the On/Off switch (J).
which stops your chuck immediately when you
quickly release the switch. It is also a variable
speed switch that delivers higher speed and
torque with increased trigger pressure. Speed is
controlled by the amount of switch trigger
depression.
WARNING
DO NOT operate for long periods at low speed
because excess heat will be produced internally.
2. The On/Off switch (J) can be locked in the OFF
position. This helps to reduce the possibility of
accidental starting when not in use. To lock the
On/Off switch, place the forward/reverse rotation
control in the center position.
For drilling and screw driving, use forward
control is moved to the left). Only use reverse
control is moved to the right) to remove screws
WARNING
NEVER change the direction of rotation when
the chuck is rotating. Wait until it has stopped!
1
1
2
Locked
10
K
J
D
Clockwise Counterclockwise
kobalttools.com
G