Applying Blood And Reading Results - OneTouch ULTRA2 User Manual

Applying blood and reading results

Once you have a blood sample and your meter shows the APPLY BLOOD screen, you are ready to obtain a blood glucose result. If your meter
does not show the APPLY BLOOD screen, remove the unused test strip and re-start the test process. See Getting a blood sample from the fingertip
in Section 3.
 Prepare to apply the sample
Keeping your finger extended and steady, move the meter and test strip toward the blood drop.
Fingertip
Do Not apply blood on the top of the test strip.
Do Not hold the meter and test strip underneath the blood drop. This may cause blood to run into the test port and
damage the meter.
 Apply the sample
Line up the test strip with the blood drop so that the narrow channel on the edge of the
test strip is almost touching the edge of the blood drop.
Gently touch the channel to the edge of the blood drop.
Be careful not to push the test strip against your fingertip or the test strip may not fill
completely.
• Do Not smear or scrape the drop of blood with the test strip.
• Do Not apply more blood to the test strip after you have moved the drop of blood away.
• Do Not move the test strip in the meter during a test.
 CAUTION: You may get an ERROR 5 message or an inaccurate result if the blood sample does not fill the confirmation window completely.
See Troubleshooting in Section 8. Discard the test strip and re-start the test process.
 Wait for the confirmation window to fill completely
The blood drop will be drawn into the narrow channel and the confirmation window should fill completely.
Confirmation
window full
When the confirmation window is full, this means you have applied enough blood. Now you can move the
test strip away from the blood drop and wait for the meter to count down from 5 to 1.
TESTING YOUR BLOOD GLUCOSE
11
Narrow channel
Full Not full