Signature Command System Operation Instructions; Control Board; Battery Installation - Majestic 500DVKHL Installation And Operating Instructions Manual

SIGnature cOMManD SySteM OperatIOn InStructIOnS

FeatureS
command center
•
Easy Access Function Operation and System Configuration
•
Operation Confirmation/Fault Diagnostic Indications (LED/
Buzzer)
•
ON/OFF/HI/Low Operation

control Board

•
Electronic Ignition
•
Pilot Lockout safety feature
•
Electric Power Regeneration from Thermopile to save
battery
•
6-hour Automatic Shut Down Option
•
Convenient NG/LP Gas Type Conversion
•
Standing Pilot/Intermittent pilot Conversion
•
Previous settings Restoration Ability
•
Uninterrupted Operation During Power Outage (Automatic
Battery Backup)
•
ON/OFF RF Remote Receiver
•
Optional Transmitter Learn Capability
ac Module
•
Easy Snap-on Design
•
Embedded Compact 120 V AC Adapter with Auto Battery
Back up Feature
•
Remote Controlled Blower, Lighting, and Auxiliary AC Outputs
transmitter
Three Flame Height Settings
Low battery Indication for Transmitter
Child Proof Lock-out
LCD Backlight
Security Codes
Thermostatic Control Mode
Three Brightness Settings for Lights
Three Speed Control for Blower
On/Off Rear Burner Control
Programmable Timer to turn blower on and off

Battery InStaLLatIOn

The Command Center uses four (4) "AA" batteries.
to Install Batteries:
1. Press down the battery door tabs and pull out to remove battery door.
2. Install the batteries as indicated on Command Center.
3. Close battery door by snapping in place.
4. When the four (4) batteries are installed the system is ready for use.
5. The batteries should be replaced when the LED indicates low battery.
73D0129
RF Receiver
ON/OFF
NG/LP
Conversion
control
Board
command
center
Master Switch
ON
LED
OFF
Figure 47 -
Signature Command System Components
rFSc
FP1917
X
Signature components
X
8/08
X
X
X
X
X
X
X
X
DVKHL Series Gas Fireplace
To Thermopile
To Sensor
To Sparker
To Command Center
To Stepper Motor
To Valve
Battery Door
AC Module
37