Indoor Unit - Toshiba RAS-13UKHP-E3 Service Manual

8-4. Indoor Unit

8-4-1. Installation place
• A place which provides the spaces around the
indoor unit as shown in the above diagram.
• A place where there is no obstacle near the air inlet
and outlet.
• A place that allows easy installation of the piping to
the outdoor unit.
• A place which allows the front panel to be opened.
CAUTION
• Direct sunlight to the indoor unit's wireless
receiver should be avoided.
• The microprocessor in the indoor unit should not
be too close to RF noise sources.
(For details, see the owner's manual.)
<Remote control>
• A place where there are no obstacles such as a
curtain that may block the signal from the indoor
unit.
• Do not install the remote control in a place exposed
to direct sunlight or close to a heating source, such
as a stove.
• Keep the remote control at least 1 m apart from the
nearest TV set or stereo equipment. (This is
necessary to prevent image disturbances or noise
interference.)
• The location of the remote control should be
determined as shown below.
(Side view) (Top view)
Indoor unit
Remote
Reception
control
range
Fig. 8-4-1
Reception
range
Remote control
* : Axial distance
8-4-2. Cutting a hole and mounting installation
plate
<Cutting a hole>
When installing the refrigerant pipes from the rear.
The center of the pipe
hole is above the arrow.
1. After determining the pipe hole position on the
mounting plate (A), drill the pipe hole (∅65 mm) at
a slight downward slant to the outdoor side.
NOTE
• When drilling a wall that contains a metal lath, wire
lath or metal plate, be sure to use a pipe hole brim
ring sold separately.
<Mounting the installation plate>
For installation of the indoor unit, use the paper pattern
on the back.
170
85
Hook
Pipe hole Thread
Indoor unit
− 44 −
FILE NO. SVM-04004
Pipe
hole
∅65 mm
100 mm
Fig. 8-4-2
62
Hook
Installation
Hook
plate
Pipe hole
7
Mounting screw
Weight
Fig. 8-4-3
82.5
1