Nilfisk-Advance CR 1100 Instructions For Use Manual
  1. Manuals
  2. Brands
  3. Nilfisk-Advance Manuals
  4. Floor Machine
  5. Cr 1100
  6. Instructions for use manual
Nilfisk-Advance CR 1100 Instructions For Use Manual

Nilfisk-Advance CR 1100 Instructions For Use Manual

Hide thumbs Also See for CR 1100:
Table of Contents

Advertisement

Quick Links

Download this manual
CR 1100, CR 1200
Instructions for Use
Nilfi sk Models: 56303004 (CR 1200), 56303005 (CR 1100 / OBS)
11/08 revised 9/10
FORM NO. 56041776
A-English

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CR 1100 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Nilfisk-Advance CR 1100

Summary of Contents for Nilfisk-Advance CR 1100

  • Page 1 CR 1100, CR 1200 Instructions for Use Nilfi sk Models: 56303004 (CR 1200), 56303005 (CR 1100 / OBS) 11/08 revised 9/10 FORM NO. 56041776 A-English...

  • Page 3: Table Of Contents

    Hopper Dust Control Filter ............A-25 Hydraulic Oil ................. A-25 Drive Wheel Gear Case Oil ............A-26 Lubrication ..................A-26 Circuit Breaker Location ............... A-26 Troubleshooting ..............A-27 – A-28 Technical Specifi cations ............... A-29 FORM NO. 56041776 - CR 1100, CR 1200 - A-3...

  • Page 4: Introduction

    Drive the machine slowly on inclines. The drive pedal will control machine speed while descending inclines. DO NOT turn the machine on an incline; drive straight up or down. The maximum rated incline for sweeping and scrubbing is 6°. The maximum rated incline during transport is 8°. A-4 - FORM NO. 56041776 - CR 1100, CR 1200...

  • Page 5: Cautions And Warnings

    Do not use on surfaces having a gradient exceeding that marked on the machine. All doors and covers are to be positioned as indicated in the instruction manual before using the machine. SAVE THESE INSTRUCTIONS FORM NO. 56041776 - CR 1100, CR 1200 - A-5...

  • Page 6: Consignes De Prudence Et De Sécurité

    N’utilisez pas sur des surfaces dont la pente dépasse celle mentionnée sur la machine. Toutes les portes et couvercles doivent être dans la position mentionnée dans le manuel d’instruction avant de mettre la machine en service. CONSERVEZ SOIGNEUSEMENT CES INSTRUCTIONS A-6 - FORM NO. 56041776 - CR 1100, CR 1200...

  • Page 7: Hopper Safety Support

    (2-3 miles per hour) and for short distances only. If the machine is to be moved long distances the rear drive wheel needs to be raised off the fl oor and placed on a suitable transport dolly. FORM NO. 56041776 - CR 1100, CR 1200 - A-7...

  • Page 8: Battery Installation

    IMPORTANT! Follow instructions packed with the battery and charger before charging the battery. Read the instructions for Charging the Battery in the Maintenance section of this manual. FIGURE 1 A-8 - FORM NO. 56041776 - CR 1100, CR 1200...
  • Page 9 ENGLISH / A-9 FIGURE 2 FORM NO. 56041776 - CR 1100, CR 1200 - A-9...

  • Page 10: Know Your Machine / Operator's Compartment

    19 Shaker Assembly Latch Left Battery Compartment Access Panel 20 Battery Main Broom Left Access Door 21 Battery Compartment Door Hopper Cover Prop Rod 22 Steering Wheel 10 Front Wheel 11 Jacking Location A-10 - FORM NO. 56041776 - CR 1100, CR 1200...
  • Page 11 30 Access Door Latch 31 Skirt Assembly 32 Inline Solution Filter 33 Solution Tank Drain Hose 34 Rear Roller Bumper 35 Squeegee Tool Handle 36 Squeegee Tool Assembly 37 Tail Light FORM NO. 56041776 - CR 1100, CR 1200 - A-11...

  • Page 12: Control Panel

    Recovery Tank Full Indicator CC Main Power Switch Vacuum System Switch DD Battery Condition Indicator Vacuum System ON Indicator Scrub System OFF Switch Scrub System Indicator Side Broom ON Side Broom ON Indicator A-12 - FORM NO. 56041776 - CR 1100, CR 1200...
  • Page 13 Control Panel JJ Main Broom Overload Indicator Light KK Emergency Battery Disconnect LL Tilt Wheel Lever MM Drive Pedal NN Brake Pedal OO Parking Brake Latch PP Operator Seat Adjustment Lever FORM NO. 56041776 - CR 1100, CR 1200 - A-13...

  • Page 14: Pre-Operational Checklist

    To mount the brushes (or pad holders) align the lugs on the brush with the holes on the mounting plate and turn to lock in place according to rotation directions shown in Figure 4. A-14 - FORM NO. 56041776 - CR 1100, CR 1200...
  • Page 15 TOP VIEW OF SCRUB DECK SHOWING DIRECTION TO ROTATE BRUSHES WHILE INSTALLING FOR EACH BRUSH MOTOR FIGURE 4 Outside arrows represent brush installation rotation direction. Inside arrows represent brush motor rotation while scrubbing. FORM NO. 56041776 - CR 1100, CR 1200 - A-15...

  • Page 16: Filling The Solution Tank

    (EDS) system. The Display Panel (UU) will display an Error Code “E1” (XX) in the lower left corner if the magnetic slider circuit board (ZZ) becomes disconnected or malfunctions. A-16 - FORM NO. 56041776 - CR 1100, CR 1200...
  • Page 17 ENGLISH / A-17 DETERGENT SYSTEM PREPARATION AND USE (EDS MODELS ONLY) FORM NO. 56041776 - CR 1100, CR 1200 - A-17...

  • Page 18: Operating The Machine

    Back the machine away from the receptacle until the hopper will clear it, and then lower the hopper (Z). NOTE: The dump door will automatically open when sweep function is resumed. A-18 - FORM NO. 56041776 - CR 1100, CR 1200...

  • Page 19: Scrubbing

    You will need to disconnect the wire harness and tether fi rst and then use at least 2 people to lift off. SERVICE NOTE: Refer to the service manual for detailed functional descriptions of all controls and optional programmability. FORM NO. 56041776 - CR 1100, CR 1200 - A-19...

  • Page 20: After Use

    *** Have your Nilfi sk Dealer check the carbon motor brushes once a year or after 300 operating hours. NOTE: Refer to the Service Manual for more detail on maintenance and service repairs. A-20 - FORM NO. 56041776 - CR 1100, CR 1200...

  • Page 21: Charging The Battery

    Tighten the vent caps. If there is acid on the battery, wash the tops of the battery with a solution of baking soda and water (2 tablespoons of baking soda to 1 quart of water). FORM NO. 56041776 - CR 1100, CR 1200 - A-21...

  • Page 22: Main Broom Maintenance

    The width of the polished strip should be the same at both ends of the broom. If the strip is tapered, move the machine to a different area and repeat steps 1-5. If the polished strip is still tapered, contact your Nilfi sk Dealer for service. FIGURE 5 A-22 - FORM NO. 56041776 - CR 1100, CR 1200...

  • Page 23: Side Broom Maintenance

    Reach under the Side Broom and remove the large Thumb-Nut holding the side broom on and remove the broom. Install the new broom by aligning the three alignment pins and pushing on. Re-install the Thumb-Nut and tighten. FIGURE 6 FORM NO. 56041776 - CR 1100, CR 1200 - A-23...

  • Page 24: Squeegee Maintenance

    4 edges are nicked, torn or worn to a large radius. Install the blade, following the steps in reverse order and adjust the squeegee tilt. FIGURE 7 A-24 - FORM NO. 56041776 - CR 1100, CR 1200...

  • Page 25: Hopper Dust Control Filter

    This machine is equipped with an Indicator Light (F) which lights if the Hydraulic Oil Filter (C / Figure 8) requires changing. The Hydraulic Filter (C / Figure 8) is found on the side of the Hydraulic Power Unit (27) as shown. FIGURE 8 FORM NO. 56041776 - CR 1100, CR 1200 - A-25...

  • Page 26: Drive Wheel Gear Case Oil

    Circuit Breaker, 20A (Side Broom Motors / F5) Circuit Breaker, 70A (Hydraulic Pump / F7) Circuit Breaker, 40A (Vacuum Motors / F8) Circuit Breaker, 40A (Power Steering / F9) Circuit Breaker, 10A (EDS / F6) FIGURE 9 A-26 - FORM NO. 56041776 - CR 1100, CR 1200...

  • Page 27: Troubleshooting

    Once the problem has been corrected, push the button in to reset the circuit breaker. If the button does not stay in, wait 5 minutes and try again. If the circuit breaker trips repeatedly, call your Nilfi sk Service Center for service. FORM NO. 56041776 - CR 1100, CR 1200 - A-27...

  • Page 28: Poor Water Pickup

    Detergent ratio slider magnet missing (replace slider) Tripped circuit breaker(s) (reset any tripped circuit breakers) Detergent pump wiring disconnected or backwards (connect or Hopper is not completely down (lower hopper completely) reconnect wiring) A-28 - FORM NO. 56041776 - CR 1100, CR 1200...
  • Page 29 Vibrations at the Hand Controls (ISO 5349-1) 0.32 m/s 0.32 m/s Vibrations at the Seat (EN 1032) 0.2 m/s 0.2 m/s Gradeability Transport 14.1% (8 14.1% (8 ° ° Cleaning 10.5% (6 ° 10.5% (6 ° FORM NO. 56041776 - CR 1100, CR 1200 - A-29...
  • Page 31 EN 61000, EN 50366 EC Machinery Directive 06/42/EC EN 12100-1, EN 12100-2, EN 294, EN 349 6.5.2010 Don Legatt, Engineering Director Nilfisk-Advance, Inc. Nilfisk-Advance A/S 14600 21st Avenue North Sognevej 25 Plymouth, MN 55447 USA DK-2605 Brøndby, Denmark ©Nilfisk-Advance Incorporated, 2010 .pas...
  • Page 32 Nilfi sk-Advance A/S Sognevej 25 DK-2605 Brøndby Denmark Tel: +45 43 23 81 00 Fax: +45 43 43 77 00 www.nilfi sk-advance.com...

This manual is also suitable for:

Cr 1200

Table of Contents