Kyocera FS-3040MFP+ Service Manual page 169

6. Release four hooks and then remove
the separation brush unit.
7. Check or replace the transfer roller and
separation brush unit and refit all the
removed parts.
CAUTION: Note the following, when
refitting the transfer roller and separa-
tion brush unit.
A: Transfer roller
To avoid damaging the bush, place the
transfer roller so that its gear does not
hit the U-shaped bush.
B: Separation brush unit
While inserting the separation holder in
place, align the ends of the holder with
the guides until they click in.
(a)The separation brush unit is inserted
into the two projections of the frame
and does not run on to the projections.
(b)The separation brush unit is firmly in
contact with the separation plate of the
frame.
NOTE:
When the periodic maintenance
(replacing the maintenance kit, see
page 2-4-4), perform maintenance
mode.:
U251 Clearing the maintenance count
(see page 1-3-26)
Hook
Separetion plate
A
Shaft
Transfer roller
U-shaped
bush
B
Guides
Separation brush unit
B-(a)
Separation brush unit
View point
B-(b)
Separetion plate
View point
1-5-28
Separation brush unit
View point
Projection
Projection
U-shaped bush
Transfer roller
Guides
Projection
Separation brush
Separation brush unit
Figure 1-5-45
2MF/2MG
Frame
Gear