Kyocera FS-3040MFP+ Service Manual page 111

Code Contents
1010 Lift motor error
During driving the lift motor,
a motor overcurrent signal
is detected for 5 s.
This error is detected five
times successively.
2000 Main motor steady-state
error
The main motor ready input
is not given for 2 s during
the main motor is ON.
2200 Drum motor steady-state
error
The drum motor ready input
is not given for 2 s during
the drum motor is ON.
Causes
Defective bottom Check to see if the bottom plate can move
plate elevation smoothly and repair it if any problem is found.
mechanism in the
cassette.
Defective connec- Reinsert the connector. Also check for continu-
tor cable or poor ity within the connector cable. If none, remedy
contact in the con- or replace the cable.
nector. Lift motor and connect-R PWB (YC8)
Connect-R PWB (YC2) and engine PWB
(YC502)
Defective drive Check if the gears rotate smoothly. If not,
transmission sys- grease the bushes and gears. Check for bro-
tem of the lift ken gears and replace if any.
motor.
Defective lift motor. Replace the lift motor
Defective engine Replace the engine PWB or connect-R PWB
PWB or connect-R and check for correct operation (see page 1-5-
PWB. 30).
Reinsert the connector. Also check for continu-
Defective connec-
tor cable or poor ity within the connector cable. If none, remedy
contact in the con- or replace the cable.
nector. Main motor and engine PWB (YC501)
Defective drive Check if the rollers and gears rotate smoothly.
transmission sys- If not, grease the bushes and gears. Check for
tem of the main broken gears and replace if any.
motor.
Defective main Replace the main motor.
motor.
Defective engine Replace the engine PWB and check for correct
PWB. operation (see page 1-5-30).
Defective connec- Reinsert the connector. Also check for continu-
tor cable or poor ity within the connector cable. If none, remedy
contact in the con- or replace the cable.
nector. Drum motor and engine PWB (YC11)
Defective drive Check if the rollers and gears rotate smoothly.
transmission sys- If not, grease the bushes and gears. Check for
tem of the drum broken gears and replace if any.
motor.
Defective drum Replace the drum motor.
motor.
Defective engine Replace the engine PWB and check for correct
PWB. operation (see page 1-5-30).
1-4-8
Check procedures/
corrective measures
2MF/2MG