Table Of Contents - Sony HCD-WZ8D Service Manual

HCD-WZ8D
NOTES ON HANDLING THE OPTICAL PICK-UP
BLOCK OR BASE UNIT
The laser diode in the optical pick-up block may suffer electrostatic
break-down because of the potential difference generated by the
charged electrostatic load, etc. on clothing and the human body.
During repair, pay attention to electrostatic break-down and also
use the procedure in the printed matter which is included in the
repair parts.
The flexible board is easily damaged and should be handled with
care.
NOTES ON LASER DIODE EMISSION CHECK
The laser beam on this model is concentrated so as to be focused on
the disc reflective surface by the objective lens in the optical pick-
up block. Therefore, when checking the laser diode emission,
observe from more than 30 cm away from the objective lens.
Laser component in this product is capable
of emitting radiation exceeding the limit for
Class 1.
The following caution label is located inside the apparatus.
CAUTION
Use of controls or adjustments or performance of procedures
other than those specified herein may result in hazardous radiation
exposure.
Notes on chip component replacement
• Never reuse a disconnected chip component.
• Notice that the minus side of a tantalum capacitor may be
damaged by heat.
Flexible Circuit Board Repairing
• Keep the temperature of soldering iron around 270˚C
during repairing.
• Do not touch the soldering iron on the same conductor of the
circuit board (within 3 times).
• Be careful not to apply force on the conductor when soldering
or unsoldering.
2
This appliance is
classified as a CLASS 1
LASER product. This
label is located on the
rear exterior.

TABLE OF CONTENTS

1. GENERAL
·········································································· 4
2. DISASSEMBLY
2-1. Case ··············································································· 7
2-2. Front Panel Assy ···························································· 8
2-3. PANEL Board, CD-TC-SW Board,
ENTER-SW Board, BACK LIGHT Board,
LCD Board ···································································· 8
2-4. 4CH-VOL Board, VIDEO Board ·································· 9
2-5. MAIN Board, REGULATOR Board,
HP AMP Board ······························································ 9
2-6. DVD Mechanism (CDM77A-DVBU20) ····················· 10
2-7. DMB03 Board ····························································· 10
2-8. MIC Board ··································································· 11
2-9. Tray (AU) ···································································· 11
2-10. MS-128 Board ····························································· 12
2-11. Base Unit ····································································· 12
2-12. Pick-up Unit (TDP022W) ··········································· 13
3. TEST MODE
···································································· 14
4. DIAGRAMS
4-1. Block Diagrams - RF Servo Section - ······················· 25
- Video Section - ····························· 26
- Audio Section - ···························· 27
- Main Section - ······························ 28
4-2. Printed Wiring Board - RF Board - ···························· 29
4-3. Schematic Diagram - RF Board - ···························· 30
4-4. Printed Wiring Board - DMB03 Board (Side A) - ····· 31
4-5. Printed Wiring Board - DMB03 Board (Side B) - ····· 32
4-6. Schematic Diagram - DMB03 Board (1/9) - ··········· 33
4-7. Schematic Diagram - DMB03 Board (2/9) - ··········· 34
4-8. Schematic Diagram - DMB03 Board (3/9) - ··········· 35
4-9. Schematic Diagram - DMB03 Board (4/9) - ··········· 36
4-10. Schematic Diagram - DMB03 Board (5/9) - ··········· 37
4-11. Schematic Diagram - DMB03 Board (6/9) - ··········· 38
4-12. Schematic Diagram - DMB03 Board (7/9) - ··········· 39
4-13. Schematic Diagram - DMB03 Board (8/9) - ··········· 40
4-14. Schematic Diagram - DMB03 Board (9/9) - ··········· 41
4-15. Printed Wiring Board - Main Section - ······················ 42
4-16. Schematic Diagram - Main Section (1/2) - ············· 43
4-17. Schematic Diagram - Main Section (2/2) - ············· 44
4-18. Printed Wiring Board - PANEL Board - ···················· 45
4-19. Schematic Diagram - PANEL Board - ···················· 46
4-20. Printed Wiring Board - LCD/Switch Section - ·········· 47
4-21. Schematic Diagram - LCD/Switch Section - ·········· 48
4-22. Printed Wiring Board - REGULATOR Board - ········· 49
4-23. Schematic Diagram - REGULATOR Board - ········· 50
4-24. Printed Wiring Board - 4CH-VOL Board - ················ 51
4-25. Schematic Diagram - 4CH-VOL Board - ················ 52
4-26. Printed Wiring Board - VIDEO/MIC Board - ············ 53
4-27. Schematic Diagram - VIDEO/MIC Board - ············ 54
4-28. IC Block Diagrams ······················································ 55
4-29. IC Pin Function Description ········································ 61
5. EXPLODED VIEWS
5-1. Front Panel Section ····················································· 70
5-2. Chassis Section ···························································· 71
5-3. DVD Mechanism Deck Section ·································· 73
6. ELECTRICAL PARTS LIST
······································· 74