Colorwriter LSR 2000 Printer
Service Guide
Preface
Handling the printer
Do not place this printer on an unstable cart, stand, or table. The
!
printer alone weighs approximately 110 lb (50 kg). It should always
be moved by two or more people. Do not attempt to move it by
yourself.
•
When installing the printer, carefully observe the location
requirement described in this manual.
•
Never place the printer near or over a radiator, heat emitter, or
flame.
•
When the printer is in use, the fixing assembly and delivery
areas become extremely hot. Be careful not to touch these areas.
CAUTION!
ATTENTION! TEMPERATURE ELEVEE
•
When moving the printer, be sure to turn the power off before
unplugging the power cable.
•
Handle all PCBs (printed circuit boards) by their edges only, but
avoid touching the contacts on the edge of the board.
Choosing a location for the Colorwriter
•
Do not expose the printer to a wet environment.
•
Do not directly expose the printer to a chemical environment,
for example, an experimental laboratory. The exterior of the
printer is made of plastic, and the outside covering may fade,
become deformed, or melt.
•
Do not install the printer where it is exposed to smoke or steam
or sun.
•
The printer should never be placed near or over a radiator or
heat register. This printer should not be placed in a built-in
installation unless proper ventilation is provided.
HOT SURFACE. AVOID CONTACT
ACHTUNG HEISS
PRECAUTION! / ATTENZIONE!
ALTA TEMPERATURA
xv