120-Volt Ac Outlets - Kenworth Y53-1024 Operator's Manual

Electric Power System
The Protection Unit houses a 20 Amp circuit breaker and a Ground Fault
Circuit Interrupter (GFCI) that provides circuit protection for the 120-Volt AC
system. The Protection Unit is located in the front of the tool box on the
driver's side of the sleeper.
The circuit breaker is located on the right side of the Protection Unit box. If
the breaker is tripped (circuit open) it can be reset by pressing the top of the
rocker switch to the ON position.
The GFCI is located on the left side of the Protection Unit box. The GFCI
will open (disconnecting the power) if a ground fault is detected on the cir-
cuit. The unit can be reset by pressing the RESET button on the top of the
GFCI.
NOTE: Replace GFCI if light on GFCI flashes. If this
is not done, outlets will not be powered.
WARNING! Electrical shock hazard. Use of a
ground-fault circuit-interrupter other than that
supplied with the Protection Unit may fail to op-
erate properly and may lead to personal injury
or equipment damage. Use only the ground-fault
circuit interrupter that is supplied with the Pro-
tection Unit.
Kenworth

120-Volt AC Outlets

Two 120-Volt AC duplex style outlets are located in the sleeper compart-
ment, one under the driver's side lower bunk, the second in the passenger
side closet. They are powered by either a 120-Volt AC electrical supply or
by the Main Batteries through the Inverter.
NOTE: The Inverter has its own low voltage discon-
nect system that will shut off power to the two duplex
outlets when the Main Battery voltage gets below 11
-Volts.
Y53-1024 12/06
120-Volt AC Outlets
- 25 -