Install Properly; Level Refrigerator-Freezer; Remove Sales Labels; Clean It - Maytag 913478 Use And Care Manual

Install properly...
Remove sales labels...
Remove the Consumer Buy Guide label, tape and
any inside labels before using the refrigerator. To
remove any remaining glue:
1. Rub briskly with thumb to make a ball then
remove.
OR
-II I I
II3
1. Allow l/2 inch (1.25 cm) space on each side and at
the top of the refrigerator for ease of installation.
2. If the refrigerator is to be against a wall, you might
want to leave extra space so the door can be
opened wider.
3. The refrigerator back can be flush against the wall.
2. Soak area with liquid hand dishwashing
detergent before removing glue as described
in step 1.
DO NOT USE rubbing alcohol or flammable or
toxic solvents, such as acetone, gasoline, carbon
tetrachloride, etc. These can damage the material.
NOTE: DO NOT REMOVE ANY PERMANENT
INSTRUCTIONS LABELS INSIDE YOUR REFRIG-
ERATOR.
Do not remove the Tech sheet fastened under
the refrigerator at the front.
Clean it...
Clean your refriger-
ator before using it.
See cleaning instruc-
tions on page 10.
Level refrigerator-freezer...
-
I
USE SCREWDRIVER
I
TO ADJUST
FRONT ROLLER
II I
VELLING SCREW
RIGHT TO RAISE;
LEFT TO LOWER
1. Remove base grille (see page 6).
2. To raise front, turn screw in direction shown.
3. To lower front, turn screw in direction shown.
4. Check with level.
5. Replace base grille (see page 8.)
SPRONG GROUNDING
TYPE WALL RECEPTACLE
REFRIGERATOR
POWER CORD
3-PRONG
GROUNDING PLUG
RECOMMENDED GROUNDING METHOD
A 115 Volt, 60 Hz., AC only 15 ampere fused and
properly grounded electrical supply is required. It is
recommended that a separate circuit serving only this
appliance be provided.
Do not use an extension cord. Use a receptacle
which cannot be turned off with a switch or pull
chain.
4