How To Remove And Install The Pullout Drawer - Maytag Bottom freezer refrigerator User Manual

I ,
NSTALLATION
CONT
How to remove and
install the pullout
drawer
WARNING
WARNING – To avoid electrical shock
which can cause severe personal
injury or death, disconnect power to
refrigerator before removing the draw-
er. After replacing the drawer, connect
power.
CAUTION
CAUTION – To avoid possible injury,
product, or property damage, you will
need two people to perform the follow-
ing instructions.
To remove:
Pull upper basket out to full extension
and lift out to remove.
Remove lower basket by lifting basket
from rail system.
5
.
Pull drawer open to full extension.
Remove Phillips screw from each side
of rail system.
Lift top of door to unhook door sup-
ports from rail system. Lift door out to
remove.
To install:
Pull both rails out to full extension.
While supporting door, hook door sup-
ports into tabs located on inside of rail.
Lower door into final position.
Replace and tighten Phillips screws
that were removed from each side of
rail system.
With drawer pulled out to full exten-
sion, insert lower basket by aligning
tabs on both sides of lower basket with
notches in rail assembly. Verify that
the basket sides are hooked securely
over the rails.
Slide upper basket into freezer. Make
sure that rear of basket hooks behind
rail catch.