Buttons And Controls - FLIR H-Series Operator's Manual

3—Operating Your H-Series Camera
3–5

Buttons and Controls

Power Button
Changing between the Off, On, and Standby power states is
controlled by the Power button. The table below describes
how the camera moves between states.
From To
State State
Off On
On Standby Momentarily press the Power button
Standby On
On Off
Standby Off
To shut off the camera completely press and hold the Power button
for eight seconds.
After holding the Power button for three
seconds the following message will be
shown in the display and the camera will
enter the Off state if the countdown
finishes.
Release the Power button at any time during this countdown to
terminate Shutdown and resume normal operation.
Note
If the camera is in the Standby state and the Power button is held
down for eight seconds, the camera will shutdown without warning.
14
Press the Power button for 1 second. (This will put the
camera in power-on bootup for about 90 seconds
before going to On.)
Momentarily press the Power button
Press and hold the Power button for 8 seconds
Press and hold the Power button for 8 seconds
H-Series Operator's Manual
Method
November 2009