Caring For The Unit And Powerboot Module - TDS Ranger Getting Started Manual

Caring for the Unit and PowerBoot Module

Cleaning the unit and PowerBoot Module
Clean with a soft cloth dampened with either water or a diluted mild
detergent. Solvents and harsh cleaning agents will quickly damage
impact-resistant plastics in the case and battery. Do not use any
chemical cleaners or put the unit in the dishwasher.
Care of the touchscreen
Use only the included stylus or other devices specifically designed
for use with touchscreens. The use of ballpoint pens, nails or other
sharp objects to operate the touchscreen will scratch and/or damage
the unit. Abrasives may scratch touchscreens. Keep the touchscreen
clean by gently wiping the display, using a soft cloth dampened
either with clean water or glass cleaner. Do not apply any cleaner
directly to the display. Do not use any abrasive cleaners.
Use the screen protectors included with the unit to keep the
touchscreen clean and protected. To apply a screen protector, first
clean the display thoroughly. Peel the backing from the screen
protector. Align the edge, and then drop the remainder onto the
display. Use a credit card, if necessary, to squeeze the air from
underneath the screen protector.
Mechanical shock
The unit is designed to resist damage for drops up to 1.22 meters
(4.0 ft). However, you should protect the display from impact,
pressure, or abrasive substances that can scratch it or crack it. The
unit should not be dropped unnecessarily
Case Vent Hole
The unit uses a GoreTex membrane at the
vent hole under the battery to equalize the
atmospheric pressure within the unit and to
prevent dust, water, etc. from entering. This
vent must remain clear of any obstruction.
Damage to the touchscreen will occur if the vent is covered.
Covering the vent with stickers and labels may void the warranty.
.
25