Caring For Your Recon - TDS Recon Getting Started Manual

Caring for your Recon

Changing the PowerBoot Module
You can purchase additional PowerBoot Modules. Before removing the
PowerBoot, back up your Recon to built-in storage. Built-in storage is
not affected by a hard reset. In the rare event that you experience a hard
reset while changing the PowerBoot, you will easily be able to restore
the state of your Recon from this fresh backup. See Recon Memory
and Backup and Restore.
With the Recon turned off, you will have at least 30 seconds to change
the PowerBoot without danger of a hard reset.
1. Before changing the PowerBoot, back up your Recon to built-in
storage using the preinstalled backup program.
2. Turn off the Recon.
3. Remove the hand strap from the Recon.
4. To unlock the PowerBoot latches,
turn them counter-clockwise until
the arrows point towards the I/O
ports. Ensure the latches on your
new PowerBoot are also in the
unlocked position.
5. Remove the PowerBoot using both
thumbs to push on the PowerBoot
as the arrows indicate.
6. Quickly (within 30 seconds) slide the new PowerBoot onto the
Recon. Lock the latches and replace the hand strap.
Cleaning the Recon
Clean the Recon with a soft cloth dampened with either water or a
diluted mild detergent. Do not put the Recon in the dishwasher.
Water
The Recon is designed to withstand accidental immersion. To maintain
Recon's water resistant seal, it is important to ensure that the screws
on the CF-Cap are tightened after replacing CompactFlash cards.
Removal of the back case torx screws, or failure to tighten the CF-Cap
screws could cause leakage, and will void your warranty.
20
Push Here