Unit Setup - TDS Ranger Getting Started Manual

Table of Contents

Advertisement

Unit Setup

1. Charge your PowerBoot Module
The PowerBoot Module
detached from the unit. Before you insert the PowerBoot into the
unit, you should charge it. The AC charger that ships with your unit
has adapters to fit almost every electrical outlet. Connect the
appropriate outlet adapter to the AC charger. Plug the charger into
an electrical outlet and plug the
barrel end of the charger into the
PowerBoot. Charge the
PowerBoot Module for
approximately 4.5 hours.
Warning! Be sure to always use the charger included with your unit.
Use of other chargers will void warranty.
2. Attach the PowerBoot Module
Align the PowerBoot Module with the unit,
with the contacts facing down. Insert the top
end of the PowerBoot Module first as shown,
and then drop the PowerBoot Module into the
unit. Secure by firmly tightening the two
screws with a coin or a screwdriver.
NOTE: The unit ships with the latest battery firmware and will
automatically check the battery firmware version and may prompt if
the battery firmware needs to be updated with files from your unit.
3. Attach the hand strap
Insert one end of the hand strap onto the
two small bolts located on the back of the
unit.
TM
that contains the batteries is shipped
Stretch the strap and
insert the other end onto the two bolts located
near the bottom of the PowerBoot Module.
3

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents