Yamaha AR240 HO Owner's Manual page 77

2) Attach the engine shut-off cord to
your PFD. Install the cord clip onto
the engine shut-off switch by push-
ing the clip groove over the nut
beneath the knob. Be sure the cord
is not wrapped around the steering
wheel or tangled in the controls.
 Engine shut-off switch
 Clip with cord
TIP:
It is not possible to start the engine
with the clip removed from the engine
shut-off switch. However, the starter
motor will turn the engine over.
3) Put the control levers in the Neutral
NOTICE:
•

•

3-17
O
peratiOn
position. The starter motor will not
operate unless the shift lever is in
Neutral. Turn the ignition key to
"Start." When the engine starts,
WARNING
release the key. If the engine does
Gasoline vapors can explode.
Operate blower for at least 4 minutes and
Check engine compartment bilge for
gasoline vapors before starting engines.
not start after 5 seconds of crank-
Do not start engines if there is a fuel leak
or loose electrical connection.
ing, release the key. Wait at least
15 seconds before trying to start
the engine again.
Never turn the ignition key to
"Start" while the engine is run-
ning. The starter mechanism
could be damaged.
If the starter motor is engaged
continuously for more than 5
seconds, the battery will be-
come quickly discharged and
it will be impossible to start the
engine. The starter motor may
also be damaged if it is engaged
continuously for more than 5
seconds.
3