Table of Contents
Advertisement
Cooling-Water Pilot Outlets
Check that water comes out from the
pilot outlets while engine is running
in the water. Refer to page 2-13 for
correct operation of the device.
NOTE: It may take up to 20 seconds
for water to reach the pilot outlets when
first launching the boat. The amount
and force of the exiting water will vary
with engine rpm.
NOTICE:
A continuous flow of water from the
pilot hole shows that water is flow-
ing through the engine cooling pas-
sages. If water is not flowing out of
the pilot hole during operation, do
not continue to run the engines.
Overheating and serious damage
could occur. See Engine Overheat
Warning System, page 2-13, for more
information.
Bimini Top SX240 and 242 Limited
Raising from the fully collapsed stor-
age position.
1) Raise the top and secure the rear
support poles to the rear support
pole mounts with the lock pins.
2) Unzip and remove the storage
cover.
3) Unfold the top by pulling to the bow
of the boat.
4) Attach the snap hooks to the strap
eyes.
5) The top should be snug and wrinkle
free. If the top is too loose or too
tight, adjust the front straps by slid-
ing the buckle up or down the strap
as needed.
3-11
O
peratiOn
3
Advertisement
Chapters
Table of Contents
