Stopping The Engine In An Emergency; Catalytic Converter; Oil Level Check - Husqvarna TR650 STRADA Owner's Manual

STOPPING THE ENGINE IN AN EMERGENCY

- In an "EMERGENCY" press the red button (1) to stop
the engine.
1
WARNING*:
Only use this button in an "EMERGEN-
CY" and use it with extreme caution es-
pecially if the motorcycle is moving at
speed.
WARNING*:
In the event of a stuck throttle or other
malfunction that causes the engine to run
uncontrollably, pull the clutch lever IMME-
DIATELY and press the engine stop switch.
Control the motorcycle by normal use of
the brakes and steering while holding the
engine stop button down.
EN - 28 SPECIFICATIONS - OPERATION - MAINTENANCE

CATALYTIC CONVERTER

- This motorcycle has an exhaust system with a cata-
lytic converter; this oxidises the exhaust fumes (car-
bon monoxide and unburned hydrocarbons) and
converts them into carbon dioxide and water vapour.
CAUTION*:
The catalytic converter reaches very high
temperatures while the motorcycle is in
use. You should therefore avoid park-
ing the motorcycle on dry grass because
there is a risk it will catch fire.
CAUTION*:
Do not tamper with and/or remove the
catalytic converter or its components;
removal of these components leads to
VEHICLE NON COMPLIANCE WITH TYPE-
APPROVAL REQUIREMENTS making it un-
suitable for use on public roads.
- Make sure there are no signs of rust or holes in the
exhaust system and that the exhaust system works
correctly; if the noise generated by the exhaust sys-
tem increases significantly, contact an authorised
HUSQVARNA Dealer.

OIL LEVEL CHECK

The oil level must be checked with the vehicle in vertical
position on a flat surface.
- Start the motorcycle and heat the engine until the
cooling fan starts; wait for another 3 minutes and
switch off the engine.
- Check the level as follows:
- Undo the cap (1) with the dipstick (2) and remove
it from the frame.
- Clean the dipstick (2) with a cloth.
- Place the dipstick (2) in the hole (3) without
screwing the cap on.
- Remove the dipstick (2) from the hole (3) and
check that the level is between the two MIN and
MAX marks.
- To top up, pour oil into the hole (3); for the type of
oil, see the section "Technical data".
CAUTION*:
Never exceed max. level.
1
2
3
MAX
MAX
MIN
MIN