Clutch Control; Rear Brake Control; Gear Shift Control - Husqvarna TR650 STRADA Owner's Manual

CLUTCH CONTROL

The clutch control lever (1) is located on the left-hand
side of the handlebar.
The position of the clutch control on the handlebar can be
adjusted by loosening the retaining screws (2).
WARNING*:
After adjustment, turn the handlebar
as far as possible to the left and make
sure that the lever does not touch the
bodywork.
A "STOP" switch on the clutch lever support allows you
to start the engine when the motorcycle is in gear or the
clutch lever is pulled (the stand must be off the ground).
CAUTION*:
Do not forget to tighten the screws (2)
after adjusting.

REAR BRAKE CONTROL

The rear brake control (1) is placed on the right-hand
side of the motorcycle.
A stop switch, during the braking action, causes the stop
light on the tail light to come on.
1
2

GEAR SHIFT CONTROL

The lever (1) is placed on the left-hand side of the en-
gine. The operator must release the lever after each gear
change to allow it to return to its central position. Neutral
position (N) is between the first and second gears.
First gear is engaged by pushing the lever downwards;
for other gears push it upwards.
The position of the gear shift lever (1) on the shaft can
be varied. To do this, loosen the screw (2), pull the lever
out and place the lever in a new position on the shaft.
Tighten the screw once operation is completed.
WARNING*: Do not push the lever too
far down!
CAUTION*: Do not shift gears without
disengaging the clutch and closing the
throttle. The engine could be damaged
by overspeed.
WARNING*: Do not downshift when
travelling at a speed that would force
the engine to overrev in the next lower
gear, or cause the rear wheel to lose
grip.
N
1
SPECIFICATIONS - OPERATION - MAINTENANCE
5
4
3
2
1
1
2
EN - 19