Start Laminating - GBC 2064-WF Instruction Manual

GBC 2064

Start Laminating

1. At this point you should have your laminator
Webbed with the appropriate material for your
application.
2. The feed table should be in the normal operating
position.
3. Close the main and Pull roll nips. Rollers should
be closed.
4. Speed is set to 3 or less and front () motor
direction is selected.
5. Press the start ( ) button.
6. Set main roller pressure between 40% – 60% for
laminating by turning the main roll lift handle.
CAUTION: If using PSA film, an air pocket may
result between the main rollers and pull rollers.
Raise the pull rollers to allow the air Pocket to
pass.
7. Make any necessary film brake tension
adjustments, pull/main roller pressure, and
clutch and/ or rewind brake tension adjustments.
8. Position the item to be laminated on the feed
table.
9. Align the leading edge of the item parallel to the
heat roller nip (Fig. 25).
10.With both hands and an outward force push the
image slower than the speed of the rollers into
the nip of the heat rollers (Fig. 26).
CAUTION: Avoid forcing the image into the
main roller nip as this action will cause the
corners of the leading edge to buckle and create a
wave.
© 2006 General Binding Corporation
Operation Manual
Figure 25
Figure 26
Page 18