Advertisement
Plunger
Push
Seal Packing
A
A
A
B
A
A
2004 COROLLA (RM1037U)
ENGINE MECHANICAL
(d)
HINT:
If the plunger does not spring out, press the slipper into the
chain tensioner with a screwdriver so that the hook is released
from the knock pin and the plunger springs out.
Turn
A62181
37.
(a)
(b)
NOTICE:
S
S
A62182
S
(c)
A
B
A
A
A
A65687
38.
(a)
A64023
–
CHAIN SUB–ASSY
Turn the crankshaft clockwise, and check that the slipper
is pushed by the plunger.
INSTALL CYLINDER HEAD COVER SUB–ASSY
Remove any old pacing (FIPG) material.
Apply seal packing to 2 locations as shown in the illustra-
tion.
Seal packing: Part No. 08826–00080 or equivalent
Remove any oil from the contact surface.
Install the cylinder head cover within 3 minutes after
applying seal packing.
Do not put into engine oil 2 hours after installing.
Install the cylinder head cover and 3 cable brackets with
the 9 bolts, 2 seal washers and 2 nuts. Uniformly tighten
the bolts and nuts, in the several passes.
Torque:
A 11 N⋅m (112 kgf⋅cm, 8 ft⋅lbf)
B 9.0 N⋅m (92 kgf⋅cm, 80 in.⋅lbf)
INSTALL IGNITION COIL ASSY
Install the 4 ignition coils with the 4 bolts.
Torque: 9.0 N⋅m (92 kgf⋅cm, 80 in.⋅lbf)
14–91
Advertisement
