For Mac Os X - Toshiba e-Studio 332s Quick Start Manual

Scanning to Local PC
8
When the balloon message saying that
the installation is complete is displayed
on the task bar, click the balloon to
check the details, and click [Close].
4
9
Press the <SCAN> key on the operator
panel.
10
Press the to select [Local PC] and
then press
OK
11
Check that [Select A Connecting PC]
is selected, and press
12
Press the to select [From WSD
Scan], and press
13
Check that the computer on which your
machine has been installed is displayed
as the destination PC.
Note
● If the machine's IP address is changed after the
installation, uninstall the machine from the computer by
following the same procedure as in
Machine to the Computer"
.
.
OK
.
OK
"Step 2 Installing Your
P.87, and then reinstall it.

For Mac OS X

„ Overview
‰ Connecting Methods
You can select either of the following connection
methods:
● Network Connection
● USB Connection
‰ Product Requirements
Your machine supports Mac OS X 10.6 to 10.7.
‰ Steps to Go
To configure the Scan to Local PC function with
Mac OS X, follow the 3 steps below:
● "Step 1 Connecting Your Machine and
Computer" P.89
● "Step 2 Installing a Scanner Driver" P.92
● "Step 3 Registering Your Computer in Network
Scanner Setup Tool" P.93
Memo
● For the network connection, you can skip step 1 if the IP
address is already set on your machine.
● You can skip step 2 if the scanner driver is already
installed on your computer.
● For the USB connection, skip step 3.
- 88 -