Turning Your Machine On And Off; Power Supply Conditions - Toshiba e-Studio 332s Quick Start Manual

Turning Your Machine On and
Off
This section explains how to turn the machine on
and off.

Power Supply Conditions

The power supply must meet the following
conditions:
Current: 110 - 127VAC
(Range 99 - 140 VAC)
220 - 240VAC
(Range 198 - 264VAC)
Frequency: 50/60 Hz ± 2%
Note
● If the power supply is unstable, use a voltage regulator.
● The maximum power consumption of this machine is
950W. Ensure that the power supply is sufficient to
operate this machine.
● We do not guarantee the operation where an
uninterruptible power system (UPS) or inverter is used.
Do not use an uninterruptible power system (UPS) or
inverter.
There is a risk of electric
WARNING
● Be sure to turn off the power switch when
attaching or removing the AC cable and earth
wire.
● Be sure to connect the earth wire to a dedicated
grounding terminal.
● Never connect the earth wire to a water pipe, gas
pipe, telephone line earth, lightning rod or the
like.
● Make sure to connect the earth wire before
connecting the AC cable to the electric socket.
● Be sure to plug in and unplug the AC cable while
holding on to the power supply plug.
● Insert the power supply plug deep into the wall
socket securely.
● Do not insert or remove the power supply plug
with a wet hand.
● Install the power cord in a place where it will not
be stepped on, and do not place anything on the
power cord.
● Do not tie the cord in a bundle.
● Do not use the power cord if damaged.
● Do not use multi-outlet adapters.
● Do not connect this machine and other electric
items to the same wall socket. If connected
simultaneously with an air-conditioner unit, a
copy machine, shredder, etc., electric noise may
interfere with machine operation. If connection
to the same wall socket as another item is
unavoidable, please use a commercial noise filter
or a commercial noise cut transformer.
● Use the attached power cord and insert it directly
with the ground terminal. Do not use power cords
for other products for the machine.
● Do not use an extension cord. When use of an
extension cord is unavoidable, use a cord rated
15A or higher.
● Use of an extension cord may cause the machine
to operate at lower than normal capacity due to
AC voltage descent.
● During printing, do not shut off the power supply
or remove the power supply plug.
● When not in use for extended periods
(consecutive holidays or extended travel), remove
the power cord from the socket.
● Do not use the attached power cord for other
products.
- 21 -
Installing Your Machine
shock and/or fire.
1