Table of Contents
Advertisement
AcquisitionControl
Make a setting of image stream and control image stream output.
Camera starts image stream output by receiving AcquisitionStrat command. And there are some registers
that require camera to stop image stream output to change values.
Acquisition frame rate is variable. Maximum acquisition frame rate depends on camera operation mode
(scalable, binning, etc.)
● Registers
Register
AcquisitionMode
AcquisitionStart
AcquisitionStop
AcquisitionAbort
AcquisitionFrameCount
AcquisitionFrameRateControl
AcquisitionFrameRate
AcquisitionFrameIntervalControl
AcquisitionFrameInterval
● Setting
- Select an acquisition mode
Set the following value to "AcquisitionMode" register. Setting value is Enumeration type.
- Set the number of frames to transfer (In MultiFrame mode)
Set the number of frames to transfer to "AcquisitionFrameCount". Setting value is Integer type.
Copyright © 2015 TOSHIBA TELI CORPORATION, All rights reserved.
Visibility
Access
Beginner
R/W
Selects an acquisition mode.
Beginner
W
Executes the image stream output start.
Beginner
W
Executes the image stream output stop.
Beginner
W
Executes the image stream output abort.
Beginner
R/W
Sets the number of frames to transfer in MultiFrame mode.
Beginner
R/W
Activates frame rate setting.
Beginner
R/W
Sets frame rate of image stream.
Beginner
R/W
Activates frame interval setting.
Beginner
R/W
Sets frame interval of image stream.
AcquisitionMode
Continuous (*)
Continuous image transfer
MultiFrame
Multi frame image transfer
40 / 77
Description
Function
* initial factory setting
http://www.toshiba-teli.co.jp/en/index.htm
D4241130B
Advertisement
Table of Contents
