Table of Contents
Advertisement
- Select the polarity of each signal
Set the following value to "LineInverterAll" register. The setting value is Integer type.
Each bit corresponds to each Line. Both Line0 and Line1 are settable.
Inverter is also inserted to UserOutputValue.
TRIG_IN
GPIO_OUT
(Line1)
GPIO_OUT
(Line2)
● Note
About the details of Timer0Active signal, refer to "TimerControl" of "Functions".
Copyright © 2015 TOSHIBA TELI CORPORATION, All rights reserved.
LineInverterAll
0 (*)
1
* initial factory setting
Line0
Line1
Line2
LineModeAll
LineInverterAll
Fig. GPIO internal circuit diagram
51 / 77
Function
non inverted
inverted
Internal Trigger
Timer0Active
TimerControl
UserOutput
UserOutputValueAll[1]
ExposureActive
FrameTransfer
FrameActive
FrameTriggerWait
UserOutput
UserOutputValueAll[2]
LineSource
http://www.toshiba-teli.co.jp/en/index.htm
D4241130B
Advertisement
Table of Contents
