Acquisitioncontrol - Toshiba teli BG Series Instruction Manual

AcquisitionControl

AcquisitionControl features are related to image acquisition.
Camera starts image stream output by receiving AcquisitionStart command.
Camera stops image stream output by receiving AcquisitionStop command.
There are some registers that require camera to stop image stream output to change values.
Acquisition frame rate is variable. Maximum acquisition frame rate depends on camera operation mode.
(scalable, pixel format, etc.)
● GenICam Node
Name
AcquisitionMode
AcquisitionStart
AcquisitionStop
AcquisitionAbort
AcquisitionFrameCount
AcquisitionFrameRateEnable
AcquisitionFrameRate
AcquisitionFrameIntervalControl
AcquisitionFrameInterval
Copyright © 2016-2018 TOSHIBA TELI CORPORATION, All Rights Reserved.
Length
Interface Access
Byte / [bit]
IEnumeration 4
ICommand 4
ICommand 4
ICommand 4
IInteger 4
IEnumeration 4
IFloat 4
IEnumeration 4
IFloat 4
68 / 160
R/W Selects an acquisition mode.
W Executes the image stream output start.
W Executes the image stream output stop.
W Executes the image stream output abort.
R/W Sets the number of frames to transfer in MultiFrame/ImageBuffer mode.
R/W Selects an AcquisitionFrameRate setting priority.
R/W Sets frame rate of image stream.
R/W Selects an AcquisitionFrameInterval setting priority.
R/W Sets frame interval of image stream.
http://www.toshiba-teli.co.jp/en/index.htm
Description
D4259344C