Heat & Glo SL-550TR-E Owner's Manual page 27

V Minimum
1
SL-550TR-E
90 Elbow ** 2 ft. 610 mm
1/2 ft.** 152 mm 6 ft. 1.8 m
1-1/2 ft.** 457 mm 10 ft. 3.0 m
2-1/2 ft.** 762 mm 12 ft. 3.7 m
3-1/2 ft. 1.1 m 14 ft. 4.3 m
V
*No specifi c restrictions on this value EXCEPT V
Fire Risk.
• When using SLP-HRC-SS and SLP-HRC-ZC-
SS termination caps on top vented fi replaces,
a one foot minimum vertical vent section is
required before installing fi rst elbow.
• When using DVP-TB1 termination cap on top vented
fi replaces, a three foot minimum vertical vent section is
required before installing fi rst elbow.
Figure 7.6
Top Vent - Horizontal Termination
Venting with three 90º elbows
H + H Maximum
1 2
SL-750TR-E SL-950TR-E
2 ft. 610 mm 2 ft.
6 ft. 1.8 m 6 ft.
10 ft. 3.0 m 10 ft.
12 ft. 3.7 m 12 ft.
14 ft. 4.3 m 14 ft.
H + H MAX. =14 ft. (4.6 m)
1 2
+ V + H + H MAX. = 40 ft. (12.2 m)
1 2 1 2
+ V + H cannot exceed 40 ft. (12.2 m)
1 2
** See warning below
H
2
WARNING **
Heat & Glo • SL-550 / 750 / 950TR-E • 2118-900 Rev. AC • 3/15
V V + V Min.
2 1 2
610 mm * *
1.8 m * *
3.0 m * *
3.7 m * *
4.3 m * *
V
2
H
Note: Use SLP Series
components only.
Note: There MUST be a 25%
reduction in total H when using
fl ex vent except when using the
simple up and out installation
(see Figure 7.3).
1
V
1
27