AVS 3010+ Owner's Manual page 6

Emergency disarm/PIN code override
impoRtaNt: please ReaD
Emergency disarm allows you to override the system if the remotes
are lost or broken (or the remote batteries are flat) so you can start
the car.
How to use PIN code for emergency disarm
1. Open the driver's door. The siren will sound.
2. Enter the car and close the door. If your car has interior light delay,
wait until the light fades out.
3. Within 30 seconds turn the ignition from OFF to ON and back to OFF
the number of times for your PIN code (5 times for the factory code)
and leave in the OFF position.
4. Wait 30 seconds until the siren stops. If the code is correct the
alarm will disarm. If the alarm does not disarm the code was
entered incorrectly. Start again from 1.
The code can be set to any number between 5 and 15. We recommend
you ask your AVS installer to change it from the factory code to a
number you choose to enhance the security of the system. Please note
that if the code is changed you must make a careful note of the new
PIN code as you will have the only record of it.