Teleco Flat Sat Elegance Smart 50 Installation And Operation Manual page 11

1) Connect the grey cable (motors) to the MOTOR UNIT connector and the white coaxial
cable (antenna) to the LNB connector of the Control Unit.
2) Connect the BLACK cable of the Control Unit to the NEGATIVE POLE of the vehicle 12
Volt Battery and the RED cable to the POSITIVE POLE + (remember not to mix
the + and - poles up), using 2 cables of 2.5 mm2 cross section.
3) The GREEN safety cable of the Control Unit must be connected to Pin 15 of the vehicle
ignition key cylinder (D+). In this way, whenever the engine is started, this cable receives
a positive +12 Vdc voltage, which will automatically lower the antenna and lock all functions
of the Control Unit simultaneously.
4) Connecting the Decoder
a) Use a coax cable to connect the RECEIVER connector of the Control Unit to the
DVB-S2 input of the TV.
b) Use the RCA - Mini AV cable to connect the Video TV connector of the Control Unit to
the RCA - Mini AV input of the TV.
c) Use the jack-jack cable to connect the " IR TV " connector of the Control Unit to the " IR
Extender " connector of the TV
Connection diagrams
10