Hardware Configuration; Jumper Setting - Contec GMB-C2165-LLVA User Manual

Hardware Configuration

2. Hardware Configuration
This chapter gives the definitions and shows the positions of jumpers, headers and
connectors. All of the configuration jumpers on GMB-C2165-LLVA are in the proper
position. The default settings shipped from factory are marked with an asterisk (★).
2.1

Jumper Setting

In general, jumpers on the single board computer are used to select options for certain
features. Some of the jumpers are designed to be user-configurable, allowing for system
enhancement. The others are for testing purpose only and should not be altered. To select
any option, cover the jumper cap over (SHORT) or remove (NC) it from the jumper pins
according to the following instructions. Here NC stands for "Not Connect".
Figure 1-1 GMB-C2165-LLVA Top-side Jumper and Connector Locations
GMB-C2165-LLVA User‟s Manual
10